Gaskets, Seals, Grommets and Rubber Parts

Handbrake Lever Gasketto fit:Classic Fiat 500 all models  (up to 1974)Fiat 126 early models (up to 1978)If you have any questions please contact us for help..

Handbrake Lever Rubber Seal Fiat Part No: 4045845to fit:Classic Fiat 500 D,F,L,R all models If you have any questions please contact us for help..

Rubber Gasket for Heater Control Valve/Cockto fit;Fiat 850Fiat 124Fiat X19Fiat UnoFiat PandaPlus many moreIf you have any questions please feel free to ask..

Product InformationHylomar 102 RTV Silicone in an 85g tubeKey FeaturesHylomar 102 RTV Silicone in an 85g tube Hylomar 102 is a black, neutral-curing amine-type silicone sealant Specified and used for its oil tolerance, particularly to new synthetic oils..

This is a Foam Gasket to fit around the Metal Hot Air Duct where it attaches to the bodywork underneaththe dashboardto fit:Classic Fiat 500 D/F/L/R/G all modelsIf you have any questions please contact us for help..

This rubber Seal site on the inside of the Oil Filler Cap and helps make the cap a tight fit so it will not leakto fit:Classic Fiat 500 D/F/L/R (up to 1974)  Not for GiardinieraFiat 126 all models (up to 1999)If you have any queries or questions please feel free to ask..

Brand New Genuine Fiat PartsThis Rubber O'Ring fits behind the Centrifugal Oil Filter Cover to stop any leaksYou should always change this O'Ring when you take the cover off to clean the filterto fit:Classic Fiat 500 all models (up to 1974)Fiat 126 all models (up to 199..

Rubber Plugs to hold the Aluminium Chassis PlateSupplied as a kit of TWO Rubber Plugs to fit:Classic Fiat 500 all modelsFiat 126 all modelsMany other Italian Car Models If you have any questions please feel free to contact us for help ..

Fibre Gasket to fit on the Pedal Boxto fit:Classic Fiat 500 N/D/F/L/G all modelsFiat 126 all modelsIf you have any questions please contact us for help..

To fit Brake & Clutch Pedal onlyDimmensions:Length 74mm ( at longest point)Width 52mmto fit:Fiat 900T/E all modelsIf you have any queries please contact us for help..

Original QualityMade by CORTECO in Italy This is a Rear Engine Crankshaft Oil Seal for Fiat 850T & 900T/E models, which rotate anti-clockwise  to fit:Fiat 850 843ccFiat 850T & 900T/E all models If you have any questions please feel free to ..

Fiat Part No: 4145587to fit:Fiat 600 all modelsFiat 600 Multipla all modelsFiat 850 all modelsFiat 900 all modelsClassic Fiat Panda  903cc & 965ccFiat Uno 903ccFiat 127 903ccAutobianchi A112If you have any questions please contact us for help..

This Rubber Blanking Plug is used to block a holeDimmensions:  to fit in hole 35mm wideto fit:Classic Fiat 500 all modelsClassic Fiat many modelsIf you have any questions please contact us for help..

This Rubber Buffer Strip fits onto the top of the Front Panel and the Bonnet stuts down on top of it to fit:classic Fiat 500 all models N/D/F/L/R/G all models If you have any questions please feel free to ask..

This Rubber Grommet has angled hole for something to run through it at an angleThis Grommet is located in the following placesFuel Hose Front Bulkhead Positive Battery Cable Inner Front Panel Speedo Cable Front BulkheadDimmensions:OD-23mmID-8mmto fit:Classic..

This Rubber Grommet is used for the floorDimmensions:  to fit in hole 15mm wideto fit:Classic Fiat 500 all modelsClassic Fiat many modelsIf you have any questions please contact us for help..

This Rubber Grommet is used to run the wiring loom through the front and rear of the carThis Grommet is located in the following placesWiring Loom Front Bulkhead Wiring Loom Rear Engine BayDimmensions:  to fit in hole 30mm wide, Hole in Middle 14mmto fit:Classic Fiat 500 a..

Complete 20 Piece Rubber Grommet Kit for all Cablesto fit:Classic Fiat 500 N,D,F,L & R all modelsIf you have any questions please contact us for help..

This Rubber Grommet is used to run the wiring loom through the front and rear of the carThis Grommet is located in the following placesFront Windscreen Washer Pipes Various other uses around Front and Rear of carDimmensions:  to fit in hole 28mm wideto fit:Classic Fiat 500..

This Rubber Grommet is used to run the wiring, hosepipes,cables etc through the rear of the car to the engine bayDimmensions:  to fit in hole 30mm wide, Hole in Middle 24mmto fit:Classic Fiat 500 all modelsClassic Fiat many modelsIf you have any questions please contac..