Axles, Shafts, Joints and Couplings

Rear Hub Flange (4 bolt type)This is a modified Flange for the largest 22mm Drive Shafts to fit:Classic Fiat 500 N/D all models  (from 1957 to 1966) If you have any questions or queries please contact our office for help..

Rear Hub Nutto fit:Classic Fiat 500 all models  (up to 1974)Fiat 126 all models (up to 1999)Fiat 600Fiat 850If you have any questions or queries please contact our office for help..

Brand New Boxed PartsSupplied complete with1x  Rear Hub Carrier1x  Rear Wheel Bearing Kit inc Nut And Spacerto fit:Classic Fiat 500 all modelsFiat 126 all modelsIf you have any questions please contact us for help ..

These Stub Axles are fully factory reconditioned in Italy using Brass Bushes to last much longerThey have new top Bushes, Pins, Washers and Bushes and are ready to fit.These Stub Axles are made for the early models of 500’s with the smaller trach rods ends (10mm track rod hole)..

This is a Reconditioned Kit of TWO Stub Axles for the Left & RightThese kits have BRAND NEW UprightsRoller BearingsTop BushesKing Pin's WashersBrass Bushes Hub Nuts x2and are readyto installThis kit is also modified with bearings top and bottom for a smoother actionSupplied with two new Hub Nuts(Onc..

This great kit replaces the Aluminium Coupling on the Drive Shaft at the wheel end and replaces it with a more robust and modern CV Joint with Tripod bearing. A must do job if you have a non standard car or engine with more power, as it eliminates a definite weak point in the driveThis grea..